ozdat.com
http://ozdat.com/forum/

H190 Diff Centres
http://ozdat.com/forum/viewtopic.php?f=2&t=34821
Page 1 of 1

Author:  JeffS620 [ Wed Oct 31, 2018 4:06 pm ]
Post subject:  H190 Diff Centres

HI All......Looking for a more highway friendly diff centre, for my Datto 620 project......happy for any advise, direction, or alternative suggestions of where I can get my hands on diff centre, that ratio starts with a 3 ??.....Happy to swap /sell the current 4.6 centre..........I only have 3 Datsun 620's, but hoping to expand my collection LOL

Author:  green200b [ Wed Oct 31, 2018 7:07 pm ]
Post subject:  Re: H190 Diff Centres

They're getting thin on the ground at wreckers yards now but probably the easiest way to find one would be to get one from a series 3 Bluebird. They are mostly 3.9:1. I'm not sure if the axle spline count is the same but worst-case you could take both diff centres to a diff shop and get them to switch the ratios over.

Author:  JeffS620 [ Fri Nov 02, 2018 3:08 pm ]
Post subject:  Re: H190 Diff Centres

Thanks Green 200B......shall look at local wreckers....like you say, they are scarce nowdays ?.......bit like rocking horse do do

Author:  d [ Wed Nov 14, 2018 12:21 am ]
Post subject:  Re: H190 Diff Centres

Just in case you dont find one I can get a 3.7 R&P from a local wreckers here in Japan
they pull them out inspect etc. for me but once you do the conversion rate they are
about $250 aud plus postage which is about 70aud. Just in case you are stuck as a
datsun 1200 ute I supplied uses a Z24 cranked L series that now revs well on the Hwy.

Page 1 of 1 All times are UTC + 10 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/